Dimensional signs
Templates, studs and straight lines.
Dimensional letters and logos are installed with concealed studs, standoffs or spacers. A full-scale paper template marks every hole, baseline and spacing before drilling, so multi-piece logos read as one intentional mark.
On stone, tile and other finished surfaces we use the right drill bits and a controlled process to avoid cracking or marking the wall.
Lobby sign planning ↗
Glass and film
Bubble-free, aligned and clean.
Frosted and decorative films need a clean surface, the right application method and precise alignment across every panel. On long glass walls and folding partitions, patterns must line up from panel to panel and from both sides of the glass.
For an executive training center we installed a double-sided privacy system across expansive folding glass walls.
See the privacy project ↗
Walls and murals
Large graphics on real surfaces.
Wall graphics depend on the surface: smooth paint, textured paint, concrete and wallcovering all behave differently. We check the surface, prepare it and choose the adhesive before the print is made, so the graphic stays flat and lasts.
We also relocate and reinstall existing artwork. For Bacardí we relocated a 25-foot-wide artwork made from thousands of individual bottle caps.
See the Bacardí relocation ↗
Coordination
Working inside occupied buildings.
Office and retail installs often happen after hours or around tenants. We coordinate access, elevators, protection of floors and finishes, and power for illuminated signs with your building manager or contractor.
We do not pull permits ourselves; we make and install the signs and work alongside the permit runner or contractor when an exterior sign needs one.